Ultra-4 Stage 1

Analog Temp:

1. Coolant temp out
2. Inlet air temp
3. Eng Oil temp
4. Trans pan temp

Analog Volt:

1. Throttle position
2. Inlet manifold pressure
3. Fuel pressure
4. Eng oil pressure

2x Bosch LSU 4.9 o2 sensors

C127 display with logging enabled and I/O enabled (fixed layouts). Display creator upgrade (add $500)

Analog Temp:

1. T-case temp

Analog Volt:

1. Brake pressure front
2. Brake pressure rear

GPS:
Motec L-10

2x PDM 30 with 1x keypad 8 (driver) and 15 (Co-driver) with override toggle switch for Ignition power, starter and master-kill. Provides over 200 continuous amps of power.

Custom Mil-spec multi-section harness built to the chassis

Main battery switch and circuit breakers included

Features:

• Stall start
• Speed/temp controlled fans
• Sensor failure alarm warnings
• High temp alarms
• Low pressure alarms
• Fuel consumption calculations ( accurate to .1 gal remaining)
• Work light activation through winch control input
• High temp limp mode(optional)
• Automated power consumption for failed alternators
• Complete circuit protection
• Overriding failing channels
• Auto Trans/ T-Case control (4L60, 4L80) (Add $2000)